You are not logged in.    Login  |  Register  |  Help
 
 

Additional Photos (Click to view Larger)
 
We are awaiting video for this item from the principals. We are awaiting literature from the principals.

For Immediate Answers Contact:
Torry Hiddema
(800) 374-5009 ext.  371
Intl. +1 (704) 841-2001
torry.hiddema@exfactory.com





If not available, try his/her backup:
Dan Wolters ext 376
dan.wolters@exfactory.com


EXF #:   CP-010706  
Brand/Model:  

CULLMAN AUTOMATION CUSTOM

Machine Type:  

COUNTERTOP SAW (OVERHEAD RAIL)

Year of Mfg.:   2011
Condition:   Good Condition   
Elect./Voltage:   440 V, 60 Cy, 3 Ph.
Value New: $ 26,500    Act Now!
Price: $   7,500 USD     (Convert)
Financing:   $ 153 National Capital Leasing
Region:   SOUTH (Click for Regional Map)

Description:

CULLMAN AUTOMATION- Automatic Counter-Top Saw with 60" cut capacity

Description: Fully Automatic Counter Top Saw with 60" cut stroke capacity and  4-1/8" height cut ability.

Machine Spec:

  • The saw carriage and guides will be mounted below the infeed table height and will be raised from under the counter top to cut from the nose position toward the backsplash. This saw will use your existing 16" saw blade to cut across counter top widths of up to 60" with a backsplash height of 4 1/8". A gravity roll conveyor will be supplied to support the counter top while cutting

    Cycle Description:
  • The operator will move the counter top forward from the Back Bender (approximately 30") into the Trim Saw making sure to keep it against the Back Bender guide. (The saw will be installed perpendicular to the edge guide on the Back Bender).
  • The operator will press the two Cycle Start buttons simultaneously to start a saw cycle. (The Cycle Start buttons will be mounted on the operators control panel).
  • Clamp cylinders will extend to hold the top in position during the cut.
  • The saw arbor will rise to the cutting position and feed thru the part.
  • After the cut is complete the saw arbor will lower and retract to the home position.
  • The clamp cylinders will retract allowing the operator to move the top forward, against the pop-up stop.
  • (3) pop-ups will be mounted at 8 foot, 10 foot, and 12 foot on a beam next to the gravity roll conveyor. Each with its own manually operated valve).
  • The operator will press the two Cycle Start buttons simultaneously to start the saw cycle to complete the part.
  •    A VFD will be used to reduce the saw feed during backsplash cut.

    *Added Buyers Bonus: (1) Complete Vacuum Master will be added to the purchase of the saw at no additional cost.
Special Note: Reduced
Comment: Very little use on this saw and the price has just been reduced!
*Dimensions: Available From Product Manager
*Weight: Please Call
Written By: Louis Sicotte
*Dimensions & Weight data are based on 3rd party information and could be incorrect; please verify & confirm if accurate dimensions & weight are required.

Terms & Conditions